| 吴伟,杨丽丽,金雪梅,金鸿莱.下颌磨牙残冠纤维桩核冠修复的有限元应力分析[J].口腔材料器械杂志,2016,25(4):183-188. |
| 下颌磨牙残冠纤维桩核冠修复的有限元应力分析 |
| Finite element analysis of stress on residual crown of mandibular molar restored with fiber posts |
| 投稿时间：2016-03-28 修订日期：2016-04-30 |
| DOI：10.11752/j.kqcl.2016.04.04 |
| 中文关键词: 磨牙 残冠 Von Mises应力 有限元分析 |
| 英文关键词:Molar Residual crown Von Mises stress Finite element analysis |
| 基金项目:上海市卫计委青年科研项目（20134y163）；上海市浦东新区卫生系统青年医学人才培养（PWRq2012-01） |
|
| 摘要点击次数: 1175 |
| 全文下载次数: 1159 |
| 中文摘要: |
| 目的 分析下颌第一磨牙残冠不同缺损壁数的情况下，不同数目、不同部位的纤维桩核冠修复的应力分布情况和应力大小。方法 利用三维有限元法建立下颌第一磨牙残冠2壁和3壁缺损情况下，不同数目和不同部位的纤维桩核冠修复模型，施加225N垂直向的静态载荷及动态载荷。记录两种载荷下各部位牙本质von Mises应力最大值和最大主应力。结果 下颌磨牙2种缺损状态在动静态载荷下，未植入纤维桩组最大Von Mises应力最大，均高于植入纤维桩组，近中植入2根纤维桩组和植入3根纤维桩组的应力分布最均匀。下颌磨牙3壁缺损在静态载荷下，植入3根纤维桩组最大，Von Mises应力明显小于其他2组。结论 2壁缺损情况下，考虑选择植入1根纤维桩。3壁缺损情况下，可以考虑通过增加纤维桩数量来分散应力，减小牙体折裂风险。 |
| 英文摘要: |
| Objective The purpose of this study was to analyze the stress magnitude and distribution of mandibular first molar with various residual crowns restored by different numbers of fiber post-core crowns. Methods Three-dimensional finite element models were created to simulate various residual crowns of two or three wall defects restored by different numbers and different parts of fiber post-core crowns. A static or dynamic load of 225N was respectively applied vertically to the occlusal surface. The maximum principal stress and Von-mises peak stress of various parts of dentin were recorded under static and dynamic loads. Result In the case of residual crowns with two wall defects, the Von-mises peak stress reached the largest value under static and dynamic loads in the group without fiber post treatment, and the stress distribution was the most uniform in 2 fiber posts group and 3 fiber posts group. In case of mandibular molars with 3 wall defects under static load, the Von Mises peak stress of 3 fiber posts group was significantly smaller than the other two groups. Conclusions One fiber post was recommended to restore the residual crowns with two wall defect. In case of residual crowns with 3 walls defect, the number of fiber post should be increased to disperse stress and thus reduce the risk of tooth fracture. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |