| 胡心怡,法晨,潘晓岗.激光扫描法建立三维数字化牙颌模型的准确性和可靠性评价[J].口腔材料器械杂志,2015,24(3):123-128. |
| 激光扫描法建立三维数字化牙颌模型的准确性和可靠性评价 |
| Evaluation of accuracy and reproducibility of 3D digital dental models with laser scanning |
| 投稿时间：2014-11-14 修订日期：2014-12-29 |
| DOI：10.11752/j.kqcl.2015.03.03 |
| 中文关键词: 激光扫描法 牙颌模型 可靠性 |
| 英文关键词:Laser scanning Digital dental models Reproducibility |
| 基金项目: |
|
| 摘要点击次数: 1517 |
| 全文下载次数: 1141 |
| 中文摘要: |
| 目的 研究应用激光扫描法建立三维数字化牙颌模型的准确性和可靠性评价。方法 选择正畸治疗患者的石膏模型24 副,采用激光扫描法对石膏模型进行扫描,建立三维数字化牙颌模型,并对其牙冠宽度、牙冠高度、牙弓宽度和牙弓长度进行测量,与手工测得的结果进行比较分析。结果 石膏模型和数字化模型所有测量项目的一致性相关系数中,除双侧上颌第一前磨牙颊尖顶之间的距离(CCC=0.6307)和上颌中切牙近中接触点到右侧第一磨牙远中接触点的距离2 项测量指标结果(CCC=0.6571)良好外,其余指标的一致性都比较接近(CCC>0.7)。所有测量项目的均数差在0.017~0.862mm 之间,平均为0.104mm,D%﹤5%,部分指标存在统计学差异,但不具有临床意义。结论 基于激光扫描技术重建的三维数字化牙颌模型中,牙冠宽度和牙冠高度的准确性高,牙弓长度其次,牙弓宽度的准确性较低。 |
| 英文摘要: |
| Objective To evaluate the accuracy and reproducibility of the 3D digital dental models prepared using laser scanning technique. Methods 24 plaster models of orthodontic patients were selected and the digital models were constructed by laser scanning, and then the width and height of crown, the length and width of dental arch were measured. The data was compared with those obtained by manual measurement. Results The concordance correlation coefficient (CCC) of all these measurements were quite good (CCC>0.7) except DU4B(CCC=0.6307) and DU1-6R(CCC=0.6571). The mean difference is from 0.017 to 0.862, and the average mean difference is 0.104, D%<5%, there were significant differences in some indicators, but it was still clinically acceptable. Conclusions In the digital dental models by laser scanning technique, the accuracy of the width and height of crown was first, followed by the length of dental arch, and then the width of dental arch. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|